Standard Diverters#
Standard diverters are polyethylene blocks with shaped surfaces designed to create a sliding effect for the components as they move together with the surface or rigid disc. The idea behind diverters (standard or of other types) is to change the position of the parts along the radius of the FlexiBowl®, so as to maximize the effectiveness of the flip and to keep them at a distance from the containment ring and from the disc clamping cap that allows the robot to pick them, without the end effector colliding with either of the two.
Diverters on surface (FlexiBowl® 500-650-800-1200)#
Recommended applications#
Option fitted by default; it is suitable for handling components without protrusions small enough to get caught between the diverter and the disc.
Mounting procedure#
Warning
Make sure the FlexiBowl® is switched off and stationary before proceeding with the mounting.
Step |
Operation |
|---|---|
1 |
Place the diverter in the dedicated seat in the containment ring |
2 |
Using a flat screwdriver, tighten the adjustment screws until the diverter is at the desired height |
3 |
Use the locking screws to lock the diverter in position |
Adjustment procedure#
Warning
Warning Make sure the FlexiBowl® is switched off and stationary before proceeding with the adjustment.
Diverters for rigid disc (FlexiBowl® 350-500E)#
Step |
Operation |
|---|---|
1 |
Loosen the screws for radial and vertical adjustment |
2 |
Place a sheet of paper between the disc and the diverter to keep it at the right distance, and tighten the vertical adjustment screws |
3 |
Place a sheet of paper between the outer surface of the diverter and the inner surface of the disc edge to keep it at the right distance, and tighten the %radial adjustment screws |
Diverters on surface (FlexiBowl® 500-650-800-1200)#
Step |
Operation |
|---|---|
1 |
Remove the plugs on the diverter cartridge |
2 |
Loosen the fixing screws (2) |
3 |
Loosen or tighten the adjustment screws (1) until the lower surface of the diverter is at ~0.1mm from the surface of the disc. Tip Place a sheet of paper between the disc and the diverter to keep it at the right distance, and tighten the vertical adjustment screws. |
4 |
Tighten the fixing screws (2) to lock the diverter in position |
Checking correct operation#
The diverters are correctly adjusted when the surface or rigid disc slides without meeting resistance and the components being handled do not get caught between the two.
For optimal operation, it is also necessary to check that:
the pre-flip diverter brings the parts into the zone of maximum flip efficiency, i.e. the central one;
the post-flip diverter moves the parts away from the edge just enough for the robot to pick them, even if a gripper that might hit the edge itself is used.