Decommissioning and Disposal#

Attention

Decommissioning and dismantling operations must be entrusted exclusively to specialised and authorised personnel.

In particular, only the personnel in charge of the dismantling phase and of end-of-life disposal may carry out:

  • Disconnection: Mechanical, electrical and pneumatic disconnection of the components according to the disassembly instructions and the design diagrams.

  • Logistics and handling: Transport of the parts from the installation site to the collection/disposal centre for the subsequent separation of the materials.

Inventory of the machine materials#

To facilitate recycling and separate collection, the main materials that make up the machine are listed below:

Main category

Specific type of material

Metal components

Painted, plastic-coated or galvanised ferritic steel.
300 / 400 series stainless steel.

Polymers and elastomers

Polyethylene plastic.
Elastomers, PTFE, graphite.

Fluids and lubricants

Gear oil.
Industrial lubrication grease.

Electrical / electronic components

Electric motors.
Electric cables with their insulating sheaths.
Electronic control devices, boards and actuators.

Attention

The machine does not contain any intrinsically toxic or harmful components or substances that would require extraordinary or special neutralisation procedures before dismantling.


Decommissioning#

If the machine is not to be used for a long period of time, it must be made safe and prepared for storage.

Decommissioning procedure#

1
Permanently disconnect the electrical and pneumatic power supply lines.
2
Protect the electrical and electronic equipment, which is particularly subject to the effects of time, humidity and dust accumulation, with suitable covers.

Important

As regards the decommissioning of modules, drives or machines from external suppliers incorporated in the plant, refer strictly to the sub-supplier manuals attached to the general technical documentation.


Disposal and Demolition#

The final demolition of the machine must be entrusted to qualified personnel, each within their own area of technical competence (mechanical, electrical, waste management). When the machine is to be sent for disposal, it must first be made completely safe.

Attention

Before starting any structural disassembly operation, verify visually and with instruments the complete disconnection of the machine from the electrical power supply and from the pneumatic power supply.

Attention

For the disassembly of off-the-shelf parts or sub-supplied material integrated into the machine supplied by ARS S.r.l., refer to the technical specifications contained in the relevant manual of the original manufacturer.

Management of waste electrical and electronic equipment (WEEE)#

Local regulatory obligations#

Attention

The Customer/User is required to strictly observe and comply with the laws and decrees in force on disposal and environmental protection in the specific country where the machine is installed.