Interface Configuration

Interface Configuration#

Note

If the system in use is FlexiVision One, the configuration is managed entirely through its dedicated interface. It is not necessary to use the FlexiBowl® software interface described in this section. Refer to the FlexiVision One Manual.

First start-up#

On first start-up of the system, follow the guided procedure below to configure communication and prepare the FlexiBowl® for use.

Step

Operation

1

Enter the IP address of the FlexiBowl® in the browser’s address bar to access the software interface. The default IP address of the FlexiBowl® is 192.168.1.10.

2

The Home page opens. Select the desired language from the drop-down menu at the top right.

3

Open the Setup page from the side menu.

4

Click Get IP to read the device’s current network parameters.

5

Enter the new IP address you want to assign to the FlexiBowl® in the dedicated fields, then click Set IP.

6

Select the desired communication type from the drop-down menu. The default option is TCP Server.

Note

The Digital I/O mode is not included in the standard configuration, but is available as an option that can be purchased separately.

7

Click Apply to confirm the communication settings.

8

Click Reboot to restart the software and make the changes effective.

Important

After the reboot, reconnect to the FlexiBowl® using the new IP address set in step 5.

Enabling the Backlight (if necessary)#

If calibration of the vision system is required, enable the backlight before proceeding:

1

Open the Main Command page from the side menu.

2

Select OPTION from the “Chose Visualization Page” drop-down menu.

3

Activate the Backlight 1 and/or Backlight 2 toggle as needed.